Stars
Compact closed-loop stepper motor driver designed for NEMA motors
MQTT gateway for ESP8266 or ESP32 with bidirectional 433mhz/315mhz/868mhz, Infrared communications, BLE, Bluetooth, beacons detection, mi flora, mi jia, LYWSD02, LYWSD03MMC, Mi Scale, TPMS, BBQ the…
Official project code for filling machine project initialized by Jentek Smart Solutions. Project is based on arduino and used a flow sensor, colored display and a water pump to fulfill the request.
ESP... The time has come to... Tasmotize!
Arduino controler for a closed-loop stepper motor
A CNC controller to use and test Grbl_ESP32
Grbl-Advanced is a no-compromise, high performance, low cost alternative for CNC milling. This version of Grbl runs on a STM32F411RE / STM32F446RE Nucleo Board. Now with backlash compensation, mult…
Ink/Stitch: an Inkscape extension for machine embroidery design
Allted / Marlin
Forked from MarlinFirmware/MarlinOptimized firmware for RepRap 3D printers based on the Arduino platform.
fra589 / grbl-Mega-5X
Forked from gnea/grbl-Mega5/6 Axis version of Grbl, the open source, embedded, high performance g-code-parser and CNC milling controller written in optimized C that will run on an Arduino Mega2560
mirecta / grbl
Forked from usbcnc/grblThis is a port of GRBL 1.1 to STM32F103 for board BL-UsbMach v.2.0 for 5 axis
This repository is based on https://github.com/usbcnc/grbl which in turn is based on https://github.com/gnea/grbl
A GCode sender (not only for lasers or plotters) for up to two GRBL controller. SVG, DXF, HPGL import. 6 axis DRO.
usbcnc / grbl
Forked from gnea/grblThis is a port of GRBL 1.1 to STM32F103 target
MK4duo Firmware Printers 3D for Arduino and Arduino due
FW for ESP8266/ESP8285/ESP32 used with 3D printer
Marlin is a firmware for RepRap 3D printers optimized for both 8 and 32 bit microcontrollers. Marlin supports all common platforms. Many commercial 3D printers come with Marlin installed. Check wit…
Open Source SMT Pick and Place Hardware and Software