Amperka/Colony set specific library

MAX6675 thermocouple amplifier. Wraps https://github.com/adafruit/MAX6675-library.

only get the out after the time delay

A crash course tutorial baked as a project

Counter, supplemented by minimum and maximum

unique 24-bit high accuracy hx-711 to measure every thing more accurate with XOD IDE time number of sample, gain is equal 80h and chose your pins for Dout and SCk connected to your module and UPD on loop or what ever you want, any issue contact : [email protected]

unique 24-bit high accuracy hx-711 to measure every thing more accurate with XOD IDE time number of sample, gain is equal 80h and chose your pins for Dout and SCk connected to your module and UPD on loop or what ever you want

A crash course tutorial baked as a project

SparkFun MAX31855K Thermocouple Breakout Arduino - max31855

I modified the Gregmotorshop library, the old one counted the time wrongly, at 30 seconds it counted the minute.

A crash course tutorial baked as a project

Adafruit MPRLS Ported Pressure Sensor Breakout - 0 to 25 PSI

A crash course tutorial baked as a project

RFID library in process ... unfinished

The following library is used for work with dimmer, it gives ability to control large ammoun of dimmer. This lib used with Leonardo, Mega, UNO, ESP8266, ESP32, Arduino M0, Arduino Zero, Arduino Due, STM32. As long as the board is supported by XOD

Various nodes utils

Node for scan i2c device address

Simple way to manage 28BYJ-48 steppers

Touch - Knob - Buzzer

Library for RTC DS1302 ....... testing

using this library you can control shift registers

First version for BME280 sensor. Based on Wayland BMP280-barometer

Reads analog signal value from ADC port. Does not check if port is a valid analog port. Arduino Unos with DIP ICs typically only have six analog ports broken out to headers: A0-A5. SMD Unos (such as the Grove Beginner Kit) also have headers for ports A6 and A7, however the function isValidAnalogPort does not consider A6 and A7 to be valid ports and so the inbuilt analog-read node cannot be used with these ports. This library provides an alternative analog-read node which doesn't check if the analog port is valid.