Just got my WiCan Pro today. Plugged it in, configured AP, switched to Auto PID. At this stage, everything is fine except all the reading I can get is the 12V battery status. So far so good.

If I goto Automate, and load Vehicle Specific PIDs (Atto 3), when I save settings, it would reboot and seem to boot back up again but immediately crashes, with blue LED slowly blinking, no Wifi connectivity at all, dead device. I have to erase config and reflash it from USB to wake the device up.

The same thing happens if I enable standard PIDs, automatic ECU protocl and try to perform a scan for available PIDs. The device would crash and disappear from Wifi with slow blinking blue LED.

Can someone help me sort out what is going on here? Right now, the WiCan Pro is just a expensive doorstop.

This is an Australia spec Atto 3 running on latest firmware 1.10.